Concrete Leveling Before & After Photos

Jodie C. called because the cement slab in her garage had several cracks and water was beginning to puddle in the area. She was concerned about the grading and wanted to know where the water was coming from. Unfortunately, the cement slab was settling, causing multiple cracks to form and allowing water to accumulate in the low points of the slab. 

In order to level the garage floor and deal with the cracks we installed the PolyLevel system and NexusPro joint sealer.

PolyLevel is used to lift sinking concrete by injecting high-density polymers that expand and lift the slab. Our team first drilled multiple small holes in the slab that we then filled with the lightweight polymers. After about 15 minutes, the polymers expand, which immediately levels the slab. To further ensure the slab does not shift and re-crack, we sealed the cracks with the NexusPro joint sealer. After the installation, the concrete was leveled and Jodie will no longer have to deal with wet and unleveled garage. 

A customer from East Grand Rapids had a garage that was not level at all and that caused her a lot of frustration (can you really blame her). They're were so many cracks in her garage from settling in poor foundation soil, it became a hazard. Luckily, we knew exactly how to fix this with our PolyLevel technology. 

PolyLevel is a polymer injection foam that we blast into the concrete to make it level and stronger than ever before.  PolyLevel worked to raise and level out the concrete slabs while dealing with the weak soils below that were no longer able to hold the weight of the home above. We drilled multiple small holes into the concrete slabs in order to inject them with a polymer material that expanded to lift and level out the concrete. Once injected, the system only needed about 15 minutes to fully cure and the slabs were then stabilized and lifted to their proper level, and stronger than ever before. Now, this homeowner will not have to worry about this ever again.

The walkway to this home in Grand Rapids, MI was sinking, proving to be not only an eyesore, but a tripping hazard. Luckily, there’s a quick and effective solution to fix this: PolyLevel. The PolyLevel systems works to raise concrete slabs by injecting high-density polymers into the slabs. This material is lightweight and dries quickly, so the sidewalk can be walked on in 15 minutes. PolyLevel dramatically improves the appearance of the sidewalk, eliminating a tripping hazard, too.

Our customer called when both the front and back sidewalks to her home became trip hazards as they sank toward the house. We used PolyLevel to stabilize and lift the concrete slabs, eliminating the trip hazards and restoring the look of the sidewalks.

Liz was looking to restore the cement in the front of her house. Over the years, the cement cracked and became un-level, causing a tripping hazard. Liz contacted Ayers and set up an inspection to determine what could be done. The specialist at Ayers decided the cement had settled, and PolyLevel would be perfect for the job!

PolyLevel injects foam below the cement, which can then be expanded with heat, allowing the cement to be leveled and stabilized! PolyLevel is noninvasive and leaves no mess! The adhesive in front of Liz's house looked night and day different, and Liz couldn't have been happier!