Concrete Leveling Before & After Photos

We do many PolyLevel jobs because the concrete is resting on poor foundation soil. However, this is not always the case. If you have read any basement job that we've written about, you know about how damaging water is to concrete, brick, and stone. So when water reoccurs on a slab of concrete, the slab will move around a lot. This homeowner has the downspout from the roof leading straight onto the walkway, which in return has made the walkway unlevel. We did two things to fix this problem permanently. First, we fixed the downspouts by adding buried downspouts which will direct the water away from the home and away from the walkway. This will also be more discrete because it is underground.

Next, we installed our advanced polymer injection foam, PolyLevel. PolyLevel worked to raise and level out the concrete slabs while dealing with the weak soils below that were no longer able to hold the weight of the home above. We drilled multiple small holes into the concrete slabs in order to inject them with a polymer material that expanded to lift and level out the concrete. Once injected, the system only needed about 15 minutes to fully cure and the slabs were then stabilized and lifted to their proper level, and stronger than ever before. Now, this homeowner will not have to worry about this ever again.

We've all been in an old basement with concrete floors, right? Have you noticed how the floor looks as if it's deteriorating?  Well, we know how to turn back time on your concrete slabs and make them BETTER than new. We can do this by installing our PolyLevel technology, as we did on this Riverdale home.

We came to this homeowners property and installed our PolyLevel in their basement, which is an advanced polymer-based injection foam. We blast this foam in through tiny holes that are just smaller than a dime. Once we do this the concrete is level and stronger than ever. PolyLevel worked to raise and level out the concrete slabs while dealing with the weak soils below that were no longer able to hold the weight of the home above. We drilled multiple small holes into the concrete slabs in order to inject them with a polymer material that expanded to lift and level out the concrete. Once injected, the system only needed about 15 minutes to fully cure and the slabs were then stabilized and lifted to their proper level, and stronger than ever before. Now, this homeowner will not have to worry about this ever again.

This Comstock Park couple had some concrete in their driveway and walkway that was starting to settle. This was causing both areas to be uneven and it was creating a trip hazard as well as collecting water in spots that should not be. We used PolyLevel and NexusPro to raise the concrete and seal the cracks. Both cure in a short amount of time so the concrete leveling system is not inconvenient to the homeowners!

The customer called when a concrete slab outside of his garage sank, causing a brick ledge to completely separate in the process and be in danger of falling over.

A few injections of PolyLEVEL raised the slab and corrected the brick ledge.

We were initially called out to this home to deal with sinking porch steps. But upon inspection we found many areas around the property that could benefit from PolyLevel injection. PolyLevel's patented polymer combination allows for a quick and thorough lifting process and a quick cure time, which means it's weight bearing again in as little as an hour.

One of the areas on the property that we fixed was the sidewalk; one slab was sinking, which created not only an eyesore, but a dangerous trip hazard.