Ayers Basement Systems Before & After Photos

Larry D. called because he had a floor that was sagging about 3/4”. The glass wall located in the bathroom above the floor was exerting too much pressure causing the floor to sag.

In order to support the sagging floor, we installed the effective SmartJack stabilizer system. This installation of this system starts by taking out a cube of soil in the ground and filling it with concrete or crushed stone. A structural footing is then placed in the fill to hold a galvanized steel column that is then connected to the girder above to stabilize the floor and potentially lift it back to its original position. 

A customer needed help keeping water out of her basement so she called our team and we installed the SuperSump Premier Sump Pump System. This system will alert you when water levels are too high and has an airtight lid to prevent any unwanted moisture or pests from entering.

Have you ever driven up the driveway and up to the garage, but in order to get into the garage you have to get over "the bump"? Well at Ayers, we know how to get rid of "the bump" and you'll see the results. One customer in Mendon had to drive over "the bump" to get into the driveway... so she called us. We drove to her property and installed our advanced PolyLevel technology.

Poly Level is a polymer injection foam that we blast into the concrete tiny holes that are smaller than dimes. One of the PolyLevel is injected, the concrete raises to its original position and becomes stronger than ever before. PolyLevel worked to raise and level out the concrete slabs while dealing with the weak soils below that were no longer able to hold the weight of the home above. We drilled multiple small holes into the concrete slabs in order to inject them with a polymer material that expanded to lift and level out the concrete. Once injected, the system only needed about 15 minutes to fully cure and the slabs were then stabilized and lifted to their proper level, and stronger than ever before. Now, this homeowner will not have to worry about this ever again.

Larry noticed multiple supportive issues with his home that he's been in since 2009. Knowing that It was built by the previous owner under little supervision, he knew he had a potentially major issue. Wanting to find a solution from a reliable company unlike the initial contractors, he contacted Ayers. Our resident foreman Blade was able to listen to Larry's concern and inspect the area.

Bruce noticed the home's crawl space was suffering the most from faulty craftsmanship.  To remedy the problem Balde and his team decided to use SmartJack piers.

SmartJack piers are steel beams place strategically along the home's supportive rim joist. The Beams are anchored into the foundational floor with poured concrete and the tops are capped with load-bearing joints that affix to the rim joist.

SmartJack is a trusted tool by Ayers because it provides a permeate source of support and not only stops further compromise of the support structures but also corrects the Supportworks over time.

Amy's home was built in the 1800s. For safety purposes, the house required new foundation support. She called Ayers for our foundation repair options, so we had a team of professionals head over for a free inspection. Our system design specialists recommended SmartJacks. This solution is installed by attaching steel support beams to the floor joists and a sturdy base installed in the subfloor. This system can be easily adjusted down the road. These adjustments will even lift the floors to a level position. Amy feels relieved now that she has permanent, upgraded foundation support for her old home!